Fasten horizontal top rails in line with top of posts fasten upper mid rail 1 3 distance down and the lower mid rail another 1 3 distance down. The safety boot can be utilized for wooden guardrail systems or cable perimeter protection as seen below.
Secure fasten safety boots to flooring using included washers and fasteners.
Safety boot guardrail system installation. Universal installation assemble cut 2×4 lumber into 42 inch lengths place into base one at a time and fasten with lag screw. If needed be sure and add toeboards following the installation instructions for the safety boot guardrail system found in this booklet. U place safety boot posts in line along all edges of.
These passive railing systems offer fall protection that doesn t require the active involvement of the worker. Safety boot tall guardrail brace installation instructions always carefully inspect each tall guardrail brace before every new installation. The three horizontal railings should be evenly spaced as shown in figure 1 on the front cover of this booklet.
X 2 inch with provided washer. Multi story general contractors depend on the safety boot guardrail system for easy to install secure guardrails that can be erected in minutes. Safety boots exceed the oh s standard and are easily moved from site to site.
Position place the boots in a line along unprotected areas no more than 8ft. Stringershield stair rail clamping system installation instructions. Safety boots exceed the federal osha standard and are easily moved from site to site.
Top of the safety boot and tap until the bottom of the post is flush with the bottom of the safety boot. Replace immediately if you notice any signs of excessive wear damage abuse rust or steel degradation. To ensure a safe installation in applications where it is intended to secure fix fasten the safety boot to plywood being used as a substrate subfloor installers must use 4 x grade 4 6 as a minimum requirement hex head bolts nuts and washers for 19mm thick plywood the correct length of bolt is 45mm.
Assemble guardrails using stress grade construction grade lumber. The safety boot can be utilized for wooden guardrail systems or cable perimeter protection as seen below. Multi story general contractors depend on the safety boot guardrail system for easy to install secure guardrails that can be erected in minutes.
Guardrail systems when you need to guard your crew from fall hazards trust 3m fall protection permanent and portable temporary guardrail systems to keep them at a safe distance. U be sure and anchor the safety boot to the post using one hex head lag screw.